In January we ordered Jeff an Uplift Desk frame, but the solid wood tops were crazy expensive; like $550-1000 expensive. I couldn't bring myself to spend that much when we have a garage full of wood and some pretty decent tools. But⏤as is so typical for us⏤neither of us had enough motivation to drive the process so the boxes just sat.
After a bit of looking around for more affordable options, I had an idea. I would look for a beat-up table on craigslist or FB marketplace and we would simply take it apart and, if necessary, sand down the top and refinish it. I obviously preferred something that was solid wood and could be cut to size without exposing the cheap inner core of veneer pieces.
Finally, I found this table on the marketplace for $25. The wood is a bit more knotty than I prefer, but it was an amazing deal and was solid wood.
It was slightly larger than would fit in Jeff's desk space so we needed to cut 3" off one edge. It took us far longer to clean up the table saw and space around it than the actual cutting. Then I got started on sanding right away and am nearly finished putting on a few coats of finish.
Hopefully, we'll finally be able to assemble the desk tomorrow but it takes 4 hours of drying time between coats of the finish, so we'll see if I can get enough in throughout the day today.
I'm still hoping once the weather gets nice outside we'll still work on something more decorative with lots of different woods for Jeff's desk, but this will do for now.
Post a Comment